Taking off grab bar, any place to get covers?
#1
#5
Cheapest option : some type of sticker's
Other option : 99-00 F4 rear plastic (market price $50-200)
Other option : 01-03 complete rear section swap (expensive)
Other option : have a machine shop custom make some covers!
I'm looking at giving the last option a shop here in a bit. Couldn't find a decent cheap F4 rear plastic, at least not yet.
On the other hand, the rear grab bar on my bike is bent to **** by the original owner. He laid the bike down and it flipped. Had it not been there it would have destroyed the rear end, but instead only bent the grab bar ($70 for oem replace all day) and slightly bent where it mounts up (already fixed). So all in all it could be a good safety piece in case you roll your bike.
Other option : 99-00 F4 rear plastic (market price $50-200)
Other option : 01-03 complete rear section swap (expensive)
Other option : have a machine shop custom make some covers!
I'm looking at giving the last option a shop here in a bit. Couldn't find a decent cheap F4 rear plastic, at least not yet.
On the other hand, the rear grab bar on my bike is bent to **** by the original owner. He laid the bike down and it flipped. Had it not been there it would have destroyed the rear end, but instead only bent the grab bar ($70 for oem replace all day) and slightly bent where it mounts up (already fixed). So all in all it could be a good safety piece in case you roll your bike.
#6
#8
Tools needed:
Sawsall,
bench vise
Various gtirs of sand paper
And if your really good, 2 leds.
Clamp handle in vise, cut off the the flared mounting portions withs sawsall. Sand rough edges. Polish if desird, paint to match if not. Add 1 large led to center of new plate as blinker or running light if desired. Voila, block off plates for the price of some spraypaint and sand paper.
There was a how to thread on here like 2 years ago
Sawsall,
bench vise
Various gtirs of sand paper
And if your really good, 2 leds.
Clamp handle in vise, cut off the the flared mounting portions withs sawsall. Sand rough edges. Polish if desird, paint to match if not. Add 1 large led to center of new plate as blinker or running light if desired. Voila, block off plates for the price of some spraypaint and sand paper.
There was a how to thread on here like 2 years ago
Thread
Thread Starter
Forum
Replies
Last Post