Pics of my bike with danmoto slip on
#41
Well though this is an older thread I figure I share my DanMoto experience nonetheless
Aside from scraping off the heat tape from Honda on the end of the headers the installation was painless.
I mean there was that one part where we had to finagle the exhaust clockwise and counter clockwise until it was clear of the swingarm (this seems to be the only design flaw as you need to have the clamp at an unnatural angle for all this to work) But it was pretty easy.
The quality was ok.. the tip has that cheap sheet metal feel, but it sounds really nice, pretty tame at idle and a nice roar when revving.
And I haven't seen any reason for a power commander as of yet. It's pretty smooth if not smoother (Probably because of the O2 deletion) And my bike is noticeably peppier. The engine spins up quicker and I know I shaved off like 20 freaking pounds from the stock exhaust.
Aside from scraping off the heat tape from Honda on the end of the headers the installation was painless.
I mean there was that one part where we had to finagle the exhaust clockwise and counter clockwise until it was clear of the swingarm (this seems to be the only design flaw as you need to have the clamp at an unnatural angle for all this to work) But it was pretty easy.
The quality was ok.. the tip has that cheap sheet metal feel, but it sounds really nice, pretty tame at idle and a nice roar when revving.
And I haven't seen any reason for a power commander as of yet. It's pretty smooth if not smoother (Probably because of the O2 deletion) And my bike is noticeably peppier. The engine spins up quicker and I know I shaved off like 20 freaking pounds from the stock exhaust.
Last edited by CityBoyRacer; 08-22-2011 at 11:23 PM.
#42
Thread
Thread Starter
Forum
Replies
Last Post
Trent Dog
F4i - Main Forum
9
07-10-2012 12:11 PM
djmnyc
600 Modifications
7
06-20-2009 08:42 AM
eee4666
CBR 600RR
15
12-31-2007 07:10 PM