well after plenty of deliberation... i decided to hack my exhaust. it actually went pretty easily. only problem i ran into is not having the right size drill bit lol. here's some pics...
BEFORE:

AFTER:

 

looks good man, i just chopper mine in half. Now its loud and looks sick!

 

i only cut 4 inches off. i wanted it a little shorter, but not super short and wicked loud.

 

I cut mine 7" but from the bolt on side. I see you don't have the akro logo on there. Did you cut from the end of it?

 

Looks awesome. Im wanting to cut 4-6" out of my TB can....just gotta find the time to do it though.

 

Yeah, I cut from the end cuz the sticker was scratched up. So I took it off too. I'm lookin for another badge or sticker to put on there.

 

Takes no more than 15 mins of your time. Its simple.

Tuned, I think it look good without the logo.

 

Yeah, it didnt take much time at all, you think so? I'll just rock it without a sticker till one just comes my way...

 

I thought there was more to it than that. I have plenty of mechanical ability but I have been lacking time for the past 6-8 months. I have a two brothers slip on and I was under the impression there was a center perforated pipe that had to be cut and rewelded as well as the outside aluminum can....

 

It is so simple: Drill out rivets, remove baffle, cut can, cut baffle, insert baffle, re-rivet can, and bolt back up..... Besides measurements, its that simple.....