CBR 929 CAMS?
#41
RE: CBR 929 CAMS?
well thae guy said base was close to 130rear wheel hp.. he said "it should be done by the end of the week" so i hope i get it back by then. i miss my baby! the only thing that i question is that when i go it dyno at another shop i was at a solid 135 rwhp.. iono.. maybe cause its a different dyno? any clues folks?
#44
RE: CBR 929 CAMS?
ORIGINAL: clean929
well thae guy said base was close to 130rear wheel hp.. he said "it should be done by the end of the week" so i hope i get it back by then. i miss my baby! the only thing that i question is that when i go it dyno at another shop i was at a solid 135 rwhp.. iono.. maybe cause its a different dyno? any clues folks?
well thae guy said base was close to 130rear wheel hp.. he said "it should be done by the end of the week" so i hope i get it back by then. i miss my baby! the only thing that i question is that when i go it dyno at another shop i was at a solid 135 rwhp.. iono.. maybe cause its a different dyno? any clues folks?
#45
#47
#48
#49
RE: CBR 929 CAMS?
aight i got it back it not as bad as i thought.. the pains was chipped in 2 spot no bigger than a dime.. over all the bill was $800, thats for the cam install,new barnett clutch kit
dyno tune..
i gave him $500 plus he will spring for the repair on the tank.. i'll post the dyno sheets tomorrow..
dyno tune..
i gave him $500 plus he will spring for the repair on the tank.. i'll post the dyno sheets tomorrow..