Hotbodies Flushmount Turn Signals
#51
#52
#53
#54
RE: Hotbodies Flushmount Turn Signals
Yes... I have the resistors in. Mine did a flicker, not a flash without the resistors. If you didn't know to look for a flash, you'd think the lights were staying on. I used the same heat shielding I used to protect my wires near my exhaust to cover the resistors. Then I tested it... after 5 minutes of flashing, they were very hot, but you could hold it and that's not going to melt plastic. If all you have is a faster rate, I'd leave it alone. I like the faster flash I had with just the CA tail light.
#56
#57
RE: Hotbodies Flushmount Turn Signals
ORIGINAL: no1biscuit
Got Mine Done late last night.
Thanks again doncollins
Mine blink fast. I looked at some load resistors but they say you can't mount them on plastic. I didn't see anywhere I could mount something like that. Anyone succeeded in this yet?
Got Mine Done late last night.
Thanks again doncollins
Mine blink fast. I looked at some load resistors but they say you can't mount them on plastic. I didn't see anywhere I could mount something like that. Anyone succeeded in this yet?
Can't wait to get mine.