another blinker problem
#1
#2
Pull your mids off and check the wiring going to the signals. Make sure that the black wires going to the green on both sides and that the solid color is going to the red wire I think its blue on the right and orange on the left.(i think) But the wire with the white stripe is your running light that shouldnt be attached to anything...
#3
#5
#6
Solid blue on the right side and solid orange on the left side.
I read that this will fix the problem:
http://www.customled.com/products/fl...sher_relay.htm
I ordered one last Friday.
#7
[/quote]I have the exact same problem on mine. I read somewhere online that the flicker is them actually trying to blink but its just to fast.
I read that this will fix the problem:
http://www.customled.com/products/fl...sher_relay.htm
I ordered one last Friday.[/quote]
let me know if that works, in the mean time I'll check my wiring.
I read that this will fix the problem:
http://www.customled.com/products/fl...sher_relay.htm
I ordered one last Friday.[/quote]
let me know if that works, in the mean time I'll check my wiring.
#9
You need to install resistors on the turn signals, they are actually blinking so fast they appear solid. I picked mine up from the local radio shack, just a ceramic 'brick' resistor, though I don't remember which resistor I used. Do a quick search and there should be plenty of posts suggesting which one to go with. If you do use a 'brick' one like I did you may want to wrap it up in electrical tape because it can get very hot.
#10