2016 RR won't start after wiring harness swap
#1
![Default](/forum/images/icons/icon1.gif)
Hello friends, my buddy is currently fixing my wrecked 2016 CBR600RR and had to replace the entire wiring harness. However, this is a CA bike and the wiring harness came from a non CA bike so there is no plug for the purge control valve. I'm wondering, would this missing connector cause the bike to not start? He says its definitely getting fuel/the fuel pump primes and doesn't think it's an air issue, I think he's gonna check for spark next. I should also mention that the bike cranks regardless of whether the kill switch is on/off. I would assume the connector not being wired up wouldn't be an issue since people delete the entire evap system off these bikes but maybe I'm wrong. Thoughts/advice?
Last edited by hellaraiser; 09-01-2024 at 12:35 PM.
Thread
Thread Starter
Forum
Replies
Last Post