it was seleina moto88 and i dont have any other pics gf had here baby and we have been in here a week already havent even got to take the bike out for a test.

 

im not going to say hong kong fairings are bad.
i am going to say they are not comparable in any way to OEM.
that being said, and if you have the patience,
mine turned out just fine for now.

 

I can say for 600RR, the Hong Kong people seem to have their mold wrong. I can say this for 600RR on tail fairings from my own experience. They are puffy and won't fit like OEM piece. I wonder if Honda makes fairings a bit different for Asian market from ours??

 

if they would of fit i would of been pretty happy i just hope they hold up over time

 

I had china made tail fairings when I crashed. It did not hold up too good. It made a big hole for a little accident. My bike got pushed over by a car in a parking lot before that with OEM fairings, and they just had scratches, but not a hole.

 

ya a fall these would bust so fast. here is a pic of the front where the head light goes its hard to see on the pic but them mounts were way off and faceing differnt than each other

 

Yep, here is the big hole


And here is how it did not fit.


Again, I have 600rr so I am not sure if it is 600rr problem or any bike problem

 

puffy is exactly how i would describe the tail for the f3 as well. way bigger than the oems i had. and they have the u.k. bar grab holes in the tail too. and they wont even mount to the center tail piece at all. dont forget none of the oem bolts work worth a crap either. if i had a better camera i would have taken about 50 pictures of things that bother me about them. but whatever. i have bigger fish to fry now (blown head gasket).

 

In this pic, I think you can tell right side "tab/lip" is longer than left side


This is OEM


This is from china. You can tell how puffy it is compare to OEM

I didn't even know they were made in China. The company is in CA

 

hey baxter did u get pics of your plastic