No spark, can anyone help?
#1
No spark, can anyone help?
I have rebuilt my CBR for track days and I am not getting a spark. The things I have checked so far is:
New spark plug coulpled in HT lead and earthed on cylinder head on all four leads... no spark.
Checked main ignition fuse. Are there anymore fuses?
I did take off the side stand along with wiring... could this bea potential fault?
Could it be the CDI unit?
Is it possible that both ignition coils have packed up.
Where do I start? Any help appreciated.
New spark plug coulpled in HT lead and earthed on cylinder head on all four leads... no spark.
Checked main ignition fuse. Are there anymore fuses?
I did take off the side stand along with wiring... could this bea potential fault?
Could it be the CDI unit?
Is it possible that both ignition coils have packed up.
Where do I start? Any help appreciated.
#2
#7
#8
RE: No spark, can anyone help?
Well personally, i would check the ignitor box. thats really all i can think about. if it was the side stand it wouldnt crank because it would kill everything (if it was removed improperly). in other words the sidestand isnt going to just stop spark its going to stop everything. doubt both coils went bad at the same time. my 2cents
#9
RE: No spark, can anyone help?
I re-assembled the side stand and it works how it should do but still no spark. The bike ran perfectly before I crashed it on it's left hand side.
Whats the procedure for checking the coils and CDI unit? The bike turns over ok.
One other question; if the kill switch is set to off, should the motor still turn over because it does?
Whats the procedure for checking the coils and CDI unit? The bike turns over ok.
One other question; if the kill switch is set to off, should the motor still turn over because it does?