Rattle & Grind... a little help please...
#1
#2
#3
RE: Rattle & Grind... a little help please...
Second Problem
This is a new one.
Shifting from 1st to 2nd. If I dont shift hard enough it will slip into nutral. I cant always get it to go into 2nd so I'll slow down and then it goes into gear just fine. This really only haoppens when I'm really rolling on the throtel. All other gars are fine but 2nd is really being a pain.
Any ideas?
Thanks for the help once again...
This is a new one.
Shifting from 1st to 2nd. If I dont shift hard enough it will slip into nutral. I cant always get it to go into 2nd so I'll slow down and then it goes into gear just fine. This really only haoppens when I'm really rolling on the throtel. All other gars are fine but 2nd is really being a pain.
Any ideas?
Thanks for the help once again...
#4
#5
RE: Rattle & Grind... a little help please...
Hows the clutch on your Cane? If the clutch is not disengaging all the way you will notice it the most between the lower gears.
Ratteling could be CCT or valves as Shadow said.
And why does this forum suck so bad for posting all of a sudden????
Ratteling could be CCT or valves as Shadow said.
And why does this forum suck so bad for posting all of a sudden????
#6
#7
RE: Rattle & Grind... a little help please...
Rattling if intermittent is likely the CCT. What year is your bike? The CC could also be stretched close to the limit making it tough for the CCT to keep all the slack out. Might be time renew both. +1 on Shadow's advice to make sure your shifter linkage is properly adjusted and +1 on Gill's advice to check out the clutch.
#8
RE: Rattle & Grind... a little help please...
Its an 88... with just over 15K.
How do I adjust the CCT?
How do I adjust thelinkage to the gearbox?
Is changing teh m a difficult task?
Im not sacred to do it I am just a litte un sure on how to proceed.... I wish that there were phone support for these things....
How do I adjust the CCT?
How do I adjust thelinkage to the gearbox?
Is changing teh m a difficult task?
Im not sacred to do it I am just a litte un sure on how to proceed.... I wish that there were phone support for these things....
#10