My first post here and I blew up two motors (95 street and 98 track) leaving water in the system. Completely forgot to bleed it out before putting away for winter in Toronto....

Have an F4 motor that belongs to a buddy and am trying to figure out if the 1999 600F4 will fit....

Thanks for replies...

Alex

 

Not sure how good you are at engines, but I have an almost complete one here https://cbrforum.com/forum/f3-sale-trade-92/lots-f3-parts-112423/ Scroll down some. Depending on how bad the engine blew, you might be able to pull parts from the blown one and put on here..

 

Thanks for the reply speed demon. I would ideally like to have a working motor (over bore kit wouldn't hurt) that I could slap in and then open up the one that has the issues. The parts motor might be a big help here but I'm hoping it's gaskets, seals, and bearings....

Fwiw, how much are you asking for your motor? How did it blow up?

 

when you say almost complete, what's missing? It'd be nice to find a local motor ie: Buffalo / Detroit so I can run over check it out and bring it back. Tennessee's a long way from here... Toronto, Canada....

 

PM sent.

 

you wouldnt happen to be willing to sell a silenoid off that motor would you? i have a 98 600 f3

 

i'm not sure what part you need but I've found a new motor and may have some spare parts. i did sell the 1995 CBR

 

i figured out how to bypass the seliniod via some help from another member here int he forum, runs great now....thought i needed the air pairing silenoid...