The purp...fighter F3 build
#34
I was going to sync the carbs today YAYY!!
Until i broke the #2 carb nipple BOOO!!
I'll try tomorrow but i did figure out this,
TIP: if you have a 10/32" (tap and die set) die, for less than $1 u can make a nipple for the #1, and in my case the #2, carb. I bought a 1/4" brass insert for a compression fitting, cut off the flare, and threaded it up about 1/4" from the other end. Fits like a glove!
Until i broke the #2 carb nipple BOOO!!
I'll try tomorrow but i did figure out this,
TIP: if you have a 10/32" (tap and die set) die, for less than $1 u can make a nipple for the #1, and in my case the #2, carb. I bought a 1/4" brass insert for a compression fitting, cut off the flare, and threaded it up about 1/4" from the other end. Fits like a glove!
#36
Thread
Thread Starter
Forum
Replies
Last Post
baboex
Street Fighters
26
09-29-2012 09:00 PM