CBR 125 Rw7 cutting out
#1
CBR 125 Rw7 cutting out
Good day to you fellow bikers.
I have recently started having problems with the above mentioned bike.
I first started noticing the problem as i was decelerating at a set of traffic lights, or before a roundabout, as soon as I held the clutch, the revs would drop to 0. Even releasing the clutch in a lower gear, trying to roll start the engine didn't work. I would have to pull over for about a minute or two, before it would decide to start up.
If i launch the bike, shifting through the gears at 11k RPM, i could manage to cruise in 4th gear at 105km/h for a bout 10-15 minutes at a time or until i caught up with traffic, reduced the speed, the engine would start to cough, cut out and i would have to pull over on the side of the road - again wait for 1-2 minutes until it would start.
This would happen at every red light, intersection, speed limit.
I've read many forums (dated 2011-2014) i was wondering if anyone had actually found a solution to this.
I have recently started having problems with the above mentioned bike.
I first started noticing the problem as i was decelerating at a set of traffic lights, or before a roundabout, as soon as I held the clutch, the revs would drop to 0. Even releasing the clutch in a lower gear, trying to roll start the engine didn't work. I would have to pull over for about a minute or two, before it would decide to start up.
If i launch the bike, shifting through the gears at 11k RPM, i could manage to cruise in 4th gear at 105km/h for a bout 10-15 minutes at a time or until i caught up with traffic, reduced the speed, the engine would start to cough, cut out and i would have to pull over on the side of the road - again wait for 1-2 minutes until it would start.
This would happen at every red light, intersection, speed limit.
I've read many forums (dated 2011-2014) i was wondering if anyone had actually found a solution to this.
#2
Thread
Thread Starter
Forum
Replies
Last Post
jayofnazareth
Other Models (125, 250, 400)
3
05-26-2011 12:08 PM