New Member from P'Cola, FL on 600rr
#1
07-15-2010 | 11:54 PM
Thread Starter
|
Junior Member
Joined: Jul 2010
Posts: 2
Likes: 0
From: Pensacola, FL
New Member from P'Cola, FL on 600rr
Hey whats up errbody... I'm Diesel(nickname), I'm new to this forum and will be looking for some advice on DIY projects in the near future. I own a 2006 CBR 600rr.. I've owned a ZX6 before but I must say that I like my Honda a lil better. I'm looking at purchasing a Dynojet Power Commander soon and I'm wondering what lvl of difficulty will it be for a beginner mechanic to complete the installation.... Thanks for any advice folks:ic
#2
07-16-2010 | 12:33 AM
Senior Member
Joined: Jul 2009
Posts: 4,471
Likes: 3
From: West Philly, PA!
Howdy and welcome aboard!
TMK, installing the entry level PCIII USB is simple. All plug n play. You just got to get to the wire connectors. Dunno the 600rr but with my F4i it'd prolly take about 5 minute + time to disconnect the connectors. If you're going for the race level Power Commander V...
Err... Good luck with that
TMK, installing the entry level PCIII USB is simple. All plug n play. You just got to get to the wire connectors. Dunno the 600rr but with my F4i it'd prolly take about 5 minute + time to disconnect the connectors. If you're going for the race level Power Commander V...
Err... Good luck with that
Thread
Thread Starter
Forum
Replies
Last Post