Turn signal?
 

To be honest I'm too lazy to search. What wires go to each other.
https://cimg3.ibsrv.net/gimg/cbrforu...1400ee6ab5.jpg
https://cimg4.ibsrv.net/gimg/cbrforu...4450b91650.jpg

What bike is it?

Totally incompatible connectors, so which is OEM?

Where did you get them non-OEM part? what model number? What type? Etc!


We're happy to help but you have to help us to help you.

I'm sorry for the lack of information. It's a 2006 F4i and the guy I bought it off took off the front turn signals. I still can't understand why. Got these replacements off eBay that I will never do again. I just have to solder them together but can't find much info. It was soft packaged and had to epoxy A piece back togther so I'm in a bad mood. Happy to be back on a CBR. It's been 15 years

Is it LED or incandescent? Is there a model number or even a manufacturers name on the packaging or on the light itself?

NO!!! DO NOT HACK UP HARNESS!! you’ll end up witb shorts and blowing fuses forever. Get factory OEM connectors and put them on aftermarket lights. You’ll need 2-wire Sumitomo connector and 1-wire ground.

https://cbrforum.com/forum/attachmen...1&d=1713713049


Follow my guide here:
https://www.600rr.net/threads/diy-co...arness.587929/

If these are LED lights, you’ll also need to install ballast resistors. Then install is simple plug-n-play. Like this.

I'm just going to buy OEM. Where is a good place to buy?

I like Partzilla.com

Ebay’s also good source for used/NOS parts for older bikes.

baboon.eu is surprisingly good deal sometimes. Recently got fuel-pump assembly for my SFV650. Even with international shipping, it was less than what local breaker yards were charging.