Fairing does not want to stay clipped in...
#1
Fairing does not want to stay clipped in...
Since I got the bike it has had this problem.
The right upper fairing does not want to stay clipped into the tank, and so it hangs off a half an inch or so...
Not noticeable to others, but an eye sore to me.
I've tried taking it off and seeing if there was something pushing the upper section off, but there does not seem to be anything protruding enough to push that section off.
The clips also seem to maybe be a little worn. Is there anything I can do you reinforce the clips to make them stay?
Any ideas?
Thanks!
The right upper fairing does not want to stay clipped into the tank, and so it hangs off a half an inch or so...
Not noticeable to others, but an eye sore to me.
I've tried taking it off and seeing if there was something pushing the upper section off, but there does not seem to be anything protruding enough to push that section off.
The clips also seem to maybe be a little worn. Is there anything I can do you reinforce the clips to make them stay?
Any ideas?
Thanks!
#6
Everything seems to be aligned, one owner, only has 6.9k miles. No scuffs on any fairing or any of the metal or frame. I took them completely off to check of it just wasn't properly installed, but it appeared to be
They will clip........ Then they pop out. The clips seems to be a little worn on the indents that would hold it on. Anything I could do I reinforce those without just putting some 3M tape under it?
They will clip........ Then they pop out. The clips seems to be a little worn on the indents that would hold it on. Anything I could do I reinforce those without just putting some 3M tape under it?