i ride an 02 F4i can anyone here with a similar bike throttle a wheelie up as apposed to slipping the clutch and if so hwo do you do it and at what RPMs ??

 

yes, its pretty simple in first gear. Get her up to about 9000-10,000RPM in first gear, then what I do is drop the throttle and pop it and it should pull that front tire right off the ground. Work with it to get it perfect. Good luck and take her ez

 

what does slipping the clutch mean???any advice on wheelies out of 1st gear

 

slipping the clutch is when you are riding and get in higher RPMs you pull in the clutch and let it right back out its like dumbing the clutch in a car but instead os pinning the tire it lifts the front end off the ground.

 

FOR STAND UP'S I LIKE TO GO ON THE FREEWAY AND WHILE IN 3RD GEAR STAND UP, RED LINE IT AT 14,000RPM'S AND BOUNCE IT WHILE DUMPING THE CLUTCH AT THE SAMETIME---FOR ME IT COMES RIGHT UP BELOW THE B.P. THEN I JUST USE THE GAS A LITTLE AND BRING IT UP JUST A BIT TO THE B.P. 2ND GEAR DO THE SAME AT ABOUT 7-8-9. 1ST GEAR STAND UP'S (DDDDDOOOOOOO NOT DO FIRST GEAR STAND UPS!!!!! ---TRUST ME ---HAHAH I KNOW----)THATS ALL I GOT TO SAY ABOUT THAT-----FIRST GEAR SIT DOWNS ARE COOL IF U CAN SHIFT GEARS---LATER AND GOOD LUCH--RICHARD

 

14,000 prm in 3rd gear? how fast are you going?

 

He must be cruisin around 60MPH and revvin it out and dropping the clutch. 14k RPM in 3rd gear is around the 120 MPH mark and there is no way that I myself would stand up on my bike at those speeds. lol

 

i tried a wheelie for the first time about 2 days ago....i tried the sitdown in first gear...roll about 10-15 mph..gun the throttle..release it ...and gun it again right away.. this will cause the fork to lift then compress and lift again..then i goes into a wheelie....but be careful..i almost looped it