Made a Chain Gaurd and Plate Mount
#1
Made a Chain Gaurd and Plate Mount
Bought my bike with no chain guard and needed one for state inspection... Decided it would be easier to take the 30 minutes and fab one up rather than buy one and wait for shipping.
This was the first design but I did not like plate sticking out to side:
So here is the second version. Welded two studs for the plate right on the guard itself.
This was the first design but I did not like plate sticking out to side:
So here is the second version. Welded two studs for the plate right on the guard itself.
#3
Bought my bike with no chain guard and needed one for state inspection... Decided it would be easier to take the 30 minutes and fab one up rather than buy one and wait for shipping.
This was the first design but I did not like plate sticking out to side:
So here is the second version. Welded two studs for the plate right on the guard itself.
This was the first design but I did not like plate sticking out to side:
So here is the second version. Welded two studs for the plate right on the guard itself.
#5
Thread
Thread Starter
Forum
Replies
Last Post