Installing a CW fender kit...
 

Installing a CW fender illiminator kit.....its a real pain in the head. Instructions are not very well explained.

Here's what we got so far......does anyone have any pointers.....
Attachment 42602

Cut with a hacksaw
Attachment 42603

Attachment 42604
Attachment 42605

Glad to help if I can. Sending PM...

ETA: This thread has a couple more pics of my install, as well as Turbulenz's... https://cbrforum.com/forum/cbr-600f4...-119446/page3/

Thank you so much....any help is needed. I just want to make sure I'm doing it right and don't cut to much off

Sure thing.

Looking at your last pic, it appears that you are right on track. There is very little difference in how my cut-back looks vs yours. I have pics from my install write-up if you need them.

Got a msg from another member asking me to go ahead & post up pic(s) of where I cut my fender back. So, here's a few. Hope these help.

Attachment 42599
Attachment 42600
Attachment 42601

Well there's your problem! :D You can't use a dog to chew down the parts for you!

Attachment 42594

^ You'll need to save those rubber grommet washers from that shovel to reuse w/ your new CW kit as well. See my pic above. The kit didn't used to come w/ those...unless it does now, you'll need 'em to secure your tail light to the brackets.

I reused my stock/oem tail light as well, as the CW kit allows for it. No need to go buy another plate light unless you really want it.

I like that kit, I've been hunting for a fender eliminator kit for mine. I'm not big on the fiberglass ones.

Would love to see more pic's of it all put back together. Also any info on where your ordered it from

I have smaller LED signals now but here's how it looked when I first installed it...

Attachment 42574

How's it goin' hondacbrgirl89?...about finished up?