I just installed a Pimpbike Undertail which I think looks amazing. Anyway... I cant figure out how I should remount the lock. So if someone has some detailed pictures of how they remounted their lock, I would greatly apprieciate it.

 

Might need this too later on. Someone come through with the help!

 

Didnt the undertail come with the pre drilled hole?

 

mines located behind where I placed the tag bracket which is just back for the raise for the taillight.

 

I hope this helps. Please excuse the dirt.

 

yea mines in about the same place but centered. Thanks for the pic Dev I was too lazy to go take one lol.

 

?Have to thread jack for just a sec. Why does everyone say excuse the dirt? That is not dirty at all. I have not washed mine since the season started. I find myself wanting to wash it but just riding instead.

 

Could someone post a picture of the locking mechanism?

 

It's not really dirty, but the undertail had mud and dirt. Its looked a lot worse than the picture showed.

Here is a photo of my locking mech. Its a crude little setup, but it works. I used a screw and screwed the triangular piece (dont know what its called) to the right side of my tray. I got frustrated after a while and didnt know what else to do with it and came up with this setup. It has worked perfectly since installed.

 

ill try and snap a few shots for ya