03 F4i - Dirty Valves
Good Evening all.
I have been reading these forums for a long time - and I always found them to be great source of info.. - Hoping I could get some advise on a 03 F4i i purchased used with 10K km - so about 6000Miles - The bike is in pritty much mint condition Bone stock- not a scratch, blemish any where.. Starts well - some while condensation smoke when starting but it goes away once it warms up.. It runs nice - I decided to pull the airfilter and change it - when I took a peek down the throttle bodies I could see alot of carbon build up on the intake valves. I expect seeing that the bike is almost 7yrs old- they probably only did a 1000miles a year.. so i assume it sat alot.. Should I be concerned? - just put some seafoam in the gas and go ride her? Any input would be appreciated. - |
does it have a power commander? if so they might have it too right, especially at idle
|
No it doesn't have a power commander...
I just installed a Yosh RC-3 Can today - |
The Techron Concentrated Complete Fuel System Cleaner is supposed to be good stuff. I'd run a bottle of that through it, then maybe a bottle of Sea Foam. Both at the 1oz. per gallon ratio. I'm kinda addicted to the SF, and put it in like every other tank full.
|
Been reading about putting 2-stroke oil in the gasoline. Here's an interesting article: LINK.
This accomplishes the same as SF, only it's way cheaper. |
Very interesting. I hope to hear more of this on this site. I think is worth trying on my truck. I will hold out on the bike until I see some results.
|
I will hold out on the bike until I see some results. |
All times are GMT -5. The time now is 11:58 PM. |
© 2024 MH Sub I, LLC dba Internet Brands