LED sequential turn arrows not working right
#1
LED sequential turn arrows not working right
anybody ever seen those yellow Led sequential turn signals? I tried hooking mine up but the sequence doesn't finish? The lights go from the edges of the arrow to the inside.......but when I hook them up they don't work properly. Is this a lack of voltage? Do I need something else to make it right? It says 12v on the box so, I figured they would work. Little help!
#3
Never seen anything like those before. What input wires do they have? Just a normal 2 wire (positive & ground) setup?
If so - connect them directly to a 12v battery just to see if they function at all.
My thinking here - is that you have a light that needs a constant 12v trigger to do it's built in sequence not one that is on a flasher relay.
If so - connect them directly to a 12v battery just to see if they function at all.
My thinking here - is that you have a light that needs a constant 12v trigger to do it's built in sequence not one that is on a flasher relay.
#4
#5
#6
#7
#8
#9
#10
Hey - not all of us :-) Just don't post, since this place turned into a ghost town.
And I'm pretty sure my advice from 8 yrs ago is still valid. It needs a constant triggered input, not a on-off-on that a flasher relay puts out.
If you tapped off of the trigger wire coming out of the turn signal switch, but before it gets to the flasher, you could run that 12v+ back to these and they would work as intended until you turned the turn signal switch off manually. If you don't have stock style turn signals at all, you could probably just pull the flasher relay and jumper across the contacts and then use the factory wiring.