https://cbrforum.com/forum/ 2000 - 2001 CBR 929RR Forum en Wed, 20 May 2026 07:21:14 GMT vBulletin 60 https://cbrforum.com/forum/images/kirsch/misc/rss.jpg https://cbrforum.com/forum/ https://cbrforum.com/forum/cbr-929rr-20/weird-clicking-juttering-need-advice-165332/ Thu, 14 May 2026 04:58:11 GMT When I shift into gear (both on and off stand) and engage the clutch while in gear I hear clicking sounds coming from near the output shaft. The output shaft seems to "jump" for lack of a better term. Its not a consistent thing with rpm and if I spin the transmission with the clutch plates removed I can't hear it while in gear. I have inspected the clutch basket and plates and all is good there. I have a new chain and sprocket kit. The noise and jumpy-ness is also there with or without the chain on. The clicking usually starts around engaging the clutch 25% and continues even to 100% engaged.

Symptoms
-Clicking noises near output shaft
-Jumpy/jerky output shaft
-Consistent in all gears (except neutral)

When it happens
-any rpm
-in any gear (except neutral) with at least 25% clutch engagement
-seems to happen whenever, not consistent with a certain spot on the output shaft
-with or without load on the output shaft (chain on/off, bike on or off stand)

What I have tried
-Inspecting clutch plates and basket for grooves (Minor grooves, but nothing to write home about, seen worse, bike has 24,000 km on it)
-new sprockets and chain (rebuilding the bike, as its a project bike)
-Tried in every gear while on stand
-Tried in first and second off stand

Any help/ideas is greatly appreciated, I believe I'll be splitting the engine apart to fix it, but would like some suggestions on what to look for before I go too far.

Thanks in advanced for any help. :)
]]> CBR 929RR zoburg88 https://cbrforum.com/forum/cbr-929rr-20/weird-clicking-juttering-need-advice-165332/ https://cbrforum.com/forum/cbr-929rr-20/wont-idle-when-hot-bogs-down-5-6000-rpm-165313/ Thu, 30 Apr 2026 06:14:52 GMT I have a 2001 929RR. I just got the bike 4 months ago. Only issues I have had was a bad ground on the fuel pump. I don't know much about these newer bikes as my other bikes are all 70's and 60's

This week I went to start the bike and it started normally. When the temp got to around 110F, the idle speed started shaking and then started dropping. At 140F it wont hold an idle. Outside temp is around 40F. Another issue that started at the same time is that is bogs down at 5-6000rpm. Runs strong to 5000, and runs strong past 6000. I have to go about half throttle to make it past the 6000 mark, then I can go full throttle again.
I have ran the bike in 20F-30F degree weather before and it has run fine.

37000 miles
Bike just was checked by a Honda dealer (Valves adjusted, new spark plugs, air filter, oil change, fluids flushed, new chain and sprockets)
Never has been dropped
Battery is from 2024 (New battery is ordered)
Full pump is good (Tested when replaced the ground) ]]> CBR 929RR tjsheeler11 https://cbrforum.com/forum/cbr-929rr-20/wont-idle-when-hot-bogs-down-5-6000-rpm-165313/