Aftermarket controllers
#1
Aftermarket controllers
As per a couple of previous posts I've had issues with my intake/exaust valve servo. Put in an illimiator module.
This winter I "gutted" the air box, insulated the bottom of it and "port matched" the exaust valve.
Now,before full warm up,it has a pretty serious "bog" at heavier throttle inputs between 3500-6000 rpm. It gets a better when fully warmed but..
Was thinking of a controller unit to smothe it out.
Anyone used a Wiseco unit?
I don't have the resources to get the full advantage of the Dyno Jet controller(re.computer down load)
And the Wisco is more cost effective seems a bit more cost effective for my situation.
Thoughts
This winter I "gutted" the air box, insulated the bottom of it and "port matched" the exaust valve.
Now,before full warm up,it has a pretty serious "bog" at heavier throttle inputs between 3500-6000 rpm. It gets a better when fully warmed but..
Was thinking of a controller unit to smothe it out.
Anyone used a Wiseco unit?
I don't have the resources to get the full advantage of the Dyno Jet controller(re.computer down load)
And the Wisco is more cost effective seems a bit more cost effective for my situation.
Thoughts
Thread
Thread Starter
Forum
Replies
Last Post
siCk f 4 i
F4i - Wanted
0
07-25-2011 04:26 AM