Rear turn signals
#12
RE: Rear turn signals
The instuctions from Hotbodies were very vague, and the pics werent clear. I figure I would just cut away the old one, and snap in the new.There were 2 fuse boxes there that werent mentioned in the instructions. 1 I had to cut around, and the other I had to cut away from the old undertail and leave in place. After that, The new one just slid and snapped into place. It wasnt really hard, just time consuming. Of course I took my time because I didnt want to make any mistakes. It was fun though. If I had to do it all over again, I could get it done in an hour. I ended up bolting the plate in to the very bottom of the undertail. Looks nice, and it is visible from the rear. I hope its legal.
#13
Thread
Thread Starter
Forum
Replies
Last Post