Pick up knobs
#13
RE: Pick up *****
if you weld onto the bottom of the existing swingarm, then you'll have offset spools...
Lockhart Phillips makes 8mm inserts that can be drilled into the swingarm. It is either in the tutorial section, or at www.cbrworld.net
It will not weaken your swingarm.
On a side note, the 954 swingarm if used with the 929 links will lower the swingarm by an inch or so. If you use the 954 link plates, it sits at the same level. I did this to mine, and the ride height is identical.
Here is a pic.
[IMG]local://upfiles/5496/49DE0C1DFFF24EE983CB637F3E16213D.jpg[/IMG]
Lockhart Phillips makes 8mm inserts that can be drilled into the swingarm. It is either in the tutorial section, or at www.cbrworld.net
It will not weaken your swingarm.
On a side note, the 954 swingarm if used with the 929 links will lower the swingarm by an inch or so. If you use the 954 link plates, it sits at the same level. I did this to mine, and the ride height is identical.
Here is a pic.
[IMG]local://upfiles/5496/49DE0C1DFFF24EE983CB637F3E16213D.jpg[/IMG]
#14
Thread
Thread Starter
Forum
Replies
Last Post