Installed the wires correctly,dont know what the problem is.
They staySolid ONand do not blink.
Installed like this:-
front signals,two wires connected to each signal(properly),they wont blink.they stay solid on!

Rear Integrated taillight installed

left turn signal stay solid ON but the right one wont even turn ON.
Any suggestions or installation instructions somewhere.Thanks

 

They're blinking, it's just going too fast to see... With led signals front and rear you'll need to wire in resistors to slow the blink speed down.

 

well the one in the back came with the resistors,so why arent they blinking??
when i was trying to install the front together they were blinking but after I closed all the fairings and turned then ON again they were just still.

 

i had the same problem w my 06 and jutsin is correct get resisters and paralell the circuit which means it bridges from pos to neg

 

explore the meaning of "parallel the circuit"
what wires to conenct where?

 

The resistors might have a bad connection. If it's those bulky white ones they break quite easily. Look into a custom led relay.