I took off my front fairining put it back on and now my bike won't start. What the heck?!?!?!? Any suggestions would be fantastic.

Thanks!!

 

Take the fairing off again and check the cables to your gauges.

 

When I took my front faring off to install my Gregg's front signals I inadvertently loosened a connector that caused my bike not to start.

 

do you remember which one and where it is? thanks

 

all gauges read on and the starter is going but no ignition...almost like it isn't firing but what I did was no where near plugs..I only removed from fairing

HELP!!

 

May have blown a fuse.....check your fuse box(connected to mid left stay bracket) it has a spare of each kind of fuse, or just make sure you connected all the hook-ups properly.

 

I never looked at it closely... but does the trip sensor by the headlight have a plug? Maybe that's loose now. If it's not even turning over, that might be worth looking at.

 

trip sensor is fine....fuses are all good...think it's a low charge from sitting (so sad, not enough sun like you socal or floirda guys or as hardcore as doncollins--rides in anything including snow) ....put a trickle charger on and fresh gas...we'll see tomorrow morning

thanks all for all the ideas

 

Before you get to take a part the bike. Make sure that it is in neutral before you try to start or that the side stand is up.
good luck!

 

lol! your awsome man! I think he knows that already though