Hey all, I have gotten the starter cable and a new solenoid. It’s getting full power but still not starting. Checked everything that I was instructed too, and still no joy.

 

Back to the start then, have you got fuel and spark at the cylinders, (by checking with all spark plugs out and earthing them)

 

I checked the spark plugs and they are sparking. I was checking to see if I had flooded it. They were mildly wet but they have spark.

 

Yes matey , they shouldnt be wet at all, so you have fuel and spark and air , now its just the wet plugs, so it you leave the spark plugs out, pull the connector to the fuel pump so it wont run, go to wide open throttle to try and dry out the cylinders (just for 10 sec) leave for another 5 mins , then plugs back in ,connect fuel pump and see if it will start

 

I will try it.

 

Forgot to say empty the fuel bowls, into a container with the drain screw

 

Ok. I will do that too. Someone else was inquiring about the pick up sensor. I have another one to try out.

 

if your getting a spark your ignition pulse sensor is ok

 

Ok

 

Yes really the true test of the ignition side is to use the Peak voltage Adaptor, that can find faults that just the Multimeter alone cant, there is a spark but is it the right kind of spark, can only assume yes at the moment