Sargent seat
#3
It is and original OEM part from Honda.
Got it when I purchased the bike back in 1988 in Puerto Rico.
It's a simple piece of fiberglass and I bet easy to make.
I read a post here before, where people were showing interest for this cowling part.
I would not mind shipping it and lending it to someone, who has fiberglass skills to reproduce it for the benefit of the community.
I'll take pictures of it off the bike and the 3 retentive brackets.
The brackets clamp around the edge of the seat.
The cowl has 3 holes, where the screws go through and screw on to the bracket.
Got it when I purchased the bike back in 1988 in Puerto Rico.
It's a simple piece of fiberglass and I bet easy to make.
I read a post here before, where people were showing interest for this cowling part.
I would not mind shipping it and lending it to someone, who has fiberglass skills to reproduce it for the benefit of the community.
I'll take pictures of it off the bike and the 3 retentive brackets.
The brackets clamp around the edge of the seat.
The cowl has 3 holes, where the screws go through and screw on to the bracket.
Last edited by Red Baron; 06-07-2014 at 12:10 PM. Reason: add photos
Thread
Thread Starter
Forum
Replies
Last Post