Hello mate,

I think you are located in australie right ?

I am from belgium (Luxemburg).

I would like 250 euros or 402 Australian dollars for all the pieces.

I have calculated what it would cost to send it via post it is 200 euros or 322 australian dollars.

So total included with shipping track and trace = 450 euro or 724 australian dollar.

I'm sorry for the high shipment amount, but that's what I also have to pay to the postaloffice.

 

 

No problem and if i could get them over to you for free i would

 

The source of the foam is most likely from the breather. Lift the tank, the right side is a small black box more toward the front. This uses to hold the degraded foam. You need to get that junk out of there and replace it with something else. I cut a piece of scotch bright and installed it. Make sure the breather tube is clear before re-assembly.

 

I know i found it , Now i put another tube on it with a small filter no more foam .

 

 

gday matey ,

My mail= zippo1966@hotmail.com

My Phone : +32 0497 06 41 31

 

 

I have just synchronized the carburetor on the bench.

because there are no connections anywhere to connect a synchronizer meter?

Not on the carburettors themselves nor on the engine ?

Strange but true.

Still waiting on the new jets .

Have already received all new rubber seals for the carburetor.

Also the new coils and leads.

 

Hi , there should be a screw head on the inlet engine side , take that out and screw your adaptor in. should be there