Cam Chain Tensioner Mods
#21
#22
#23
#24
Install as usual,lightly tighten the bottom nut, spin the engine over,then retighten. The idea is to not add much more tension than the OEM spring does, you are just backing up the hydraulic portion of the tensioner. Use Locktite before lowering the upper nut, using it as a locknut. Use a piece of wire (safety wire) to secure the end of bolt to the upper chain guide in case of the bolt failing. A reajustment after 2-300 mi. might be needed. As stated before this mod has been tested for less than 4,000 mi.. If anyone has a failure after this mileage, PLEASE report.
#25
Mate,
that's a nice neat idea.
Thanks for the write up. I may just have to try that with one of my old tensioners.
Just a thought but did the oil plate fit over the tensioner ok after the mods. You know the thing I mean? It captures oil and funnels it into the oil cup.
Anyway, great work mate. I'd like to hear how it lasts in the long term. Don't forget to update after a few more miles.
You may just have cracked the old problem.
that's a nice neat idea.
Thanks for the write up. I may just have to try that with one of my old tensioners.
Just a thought but did the oil plate fit over the tensioner ok after the mods. You know the thing I mean? It captures oil and funnels it into the oil cup.
Anyway, great work mate. I'd like to hear how it lasts in the long term. Don't forget to update after a few more miles.
You may just have cracked the old problem.
#26
Henry, there is no installation issues. The oil deflector/guide installs as usual. My only concern is the possibility of stress causing cracks forming from the pivot hole to the newly ground away area. Those with higher skills than mine may consider adding bracing to that area, after installing the bolt. Only time will tell if that will be neccessary. For those in the No. hemisphere, enjoy the summer and ride safe.
#27
Developed a muted rattle at approx 3800 mi., between 15-2500 rpm. Found some play in adj. bolt, tightened 1/8th turn until snug and noise is gone. Hope that I will not have to readjust that often in future. Forgot to mention that you will want to also weld the washer to the bottom nut before assembly, and you have to bend a 10mm wrench in order to adj./hold bottom nut. Photo of installed tensioner is not that good, but I included it anyway. Purchased and installed low mileage carbs from a fellow member this spring, made a jet needle clip position adjustment while I was "in there" and now the old girl runs real nice.
#28
#29
#30
I have been reading this thread, I recently purchased a 1991 1000f, has a great deal of cam chain noise until she warms up, then I don't hear it. What will happen if I let this go, I don't ride hard, although I enjoy taking off hard when conditions permit, I primarily enjoy touring with the bike
I am not afraid to wrench on the bike, but not real sure of my fabricating skills.
Suggestions?
I am not afraid to wrench on the bike, but not real sure of my fabricating skills.
Suggestions?