Anyone know how to remove the 2 bolts holding the gas tank down? It's not the 2 that are near the front. It's the one under the rider's seat. They're SUPER tight and bends the metal on the tools when I try to turn it.

 

try loosening the front ones then hitting the rears again. also, pb blaster, wd40, etc. will help tremendously.

 

They're hard to get loose sometimes... what I did was used the shorter end of the hex key for turning arm so that it doesnt flex, and extended it with the sleeve meant for back-shock nut adjuster. And then just didnt tighten it all that much the next time...

 

dont they have loctite on them?

 

Also try using a "cheater bar". this may help. Make sure you don't strip them or else your screeeeewed.